Atmel AVR AVRISP mkII AVR ISP mk2 USB XPII Debugger Programmer for Studio 4/5/6

Atmel AVR AVRISP mkII AVR ISP mk2 USB XPII Debugger Programmer for Studio 4/5/6

• AVR ISP Programmer, compatible with AT AVRISP mkII from ATMEL
• A professional In-System Programmer. Supports all AVR devices with ISP or PDI interface, including XMEGA
• Supports AVR Studio 4/5/6 (delivered with firmware for AVR Studio 5, can be updated to support AVR Studio 4/6)

Features:

• Supports all AVR devices with ISP or PDI interface, and certain 51 Devices
• Programs both Flash and EEPROM
• Supports Fuses and Lock Bit Programming
• Based on AT AVRISP mkII firmware
• Upgradable to Support Future Devices
• Adjustable ISP programming speed up to 8M frequency
• USB 2.0 compliant (full speed, 12Mbps)
• 3 optional cables to target board
• Powered from USB bus, does not require external power supply

Performance:

- High speed programs FLASH , EEPROM, Fuses, and Lock Bit
- It takes only 2.5S to program a 12K program file with verification (programming speed was set to 1M while the Max speed could be up to 8M)

Connects to PC:

- Uses a USB interface for communication with the front-end software (Probably AVR Studio)
- Using PDIUSBD12, USB 1.1 (USB 2.0 Full Speed) 12Mbits/second
- Each USB AVRISP XPII has a unique ID, a PC could connects to several Devices at the same time

Connects to target board:

The USB AVRISP XPII connects to the target board through 3 optional cables. Depending on the existed connector on the target board, the cable has to be changed accordingly.
- Standard 6-pin ISP Connector, Using 6-pin ISP cable
- Standard 10-pin ISP Connector, Using 6-pin to 10-pin ISP cable
- Custom ISP Connector, Using 6-wire multicolour custom connector cable

Powered from USB bus:

- Draws power from the USB bus, No need for Additional Power Supply
- The target board should be powered from Another Power Supply

Refer to AVR Studio 5, the following devices are supported: